Safety Precautions - König Electronic DL-DANCER250 Manual

Problem
Fixtures reset correctly but
some respond erratically or
not at all to controller.
A number appears in display
and fixture will not run a
standalone light show.
An effect fails to reset
correctly.
Lamp cuts out intermittently
or burns out too quickly.
Fixture does not respond
correctly to music beat in
music trig mode.
SPECIFICATIONS:
• Multi-color
• 14 Rotating gobo patterns
• DMX-512/3 channels
• Standalone auto mode
• Sound-activated
• Master/slave function
• Menu display
• Fan-cooled
• Adjustable mounting bracket
• Lamp: ELC 24 V/250 W GX5.3 (included)
• Power supply: 230 V AC, 50/60 Hz
• Dimensions (WxHxD): 365x195x365mm
• Weight: 4.3kg

Safety precautions:

CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
from mains and other equipment if a problem should occur.
Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or damage
caused due to incorrect use of this product.
General:
Designs and specifications are subject to change without notice.
All logos brands and product names are trademarks or registered trademarks of their respective
holders and are hereby recognized as such.
All manuals and user guides at all-guides.com
Probable cause
One of the fixtures is defective.
Fixture is set to DMX mode
and is displaying its DMX
address.
The effect may require
mechanical adjustment.
Fixture is too hot.
Music level sensitivity is
incorrectly adjusted.
To reduce risk of electric shock, this product should ONLY be opened by
an authorized technician when service is required. Disconnect the product
6
Solution
Bypass one fixture at a time
(unplug both DMX connectors
and connect them directly
together) until normal operation
is regained. Defective fixture has
to be serviced by a technician.
Use control panel to change
fixture from DMX to standalone
auto trig or music trig.
Contact a qualified technician for
service.
Allow fixture to cool. Check that
there is free airflow around the
fixture. Check and if necessary
clean, fan and grills.
Use control panel to adjust
sensitivity until fixture responds
satisfactorily.