RISCO Group WL S42 Instrucciones De Instalación Y Programación página 4

Mounting the Sounder
1. Release the mounting bracket captive locking screw (Fig 1).
2. Turn the mounting bracket counterclockwise and separate it from the
sounder.
3. Hold the mounting bracket against the wall (direction arrow pointing up)
and mark the locations of the mounting holes (Fig. 2). Drill the desired
mounting holes and insert screw anchors (if required).
NOTE:
Do not drill through the mounting bracket.
4. Mount the bracket to the wall using the supplied screws.
5. Insert the supplied batteries into the battery chambers (speaker and
radio) paying attention to the polarity (Fig 3).
6. Perform
Sounder/Receiver Communication Set up paragraph).
7. Once communication setup is completed, mount the sounder to the
mounting bracket by turning the sounder clockwise. Pay attention to the
tamper switch.
8. Secure the captive locking screw.
Fig. 1
Wireless Sounder Instructions
communication set up with the control panel
Mounting
Bracket
Fig. 2
(see
Tamper
Protection
Screw
4