RISCO Group WL S42 Instrucciones De Instalación Y Programación página 5

Programming the sounder
Programming the wireless sounder consists of the following 3 steps:
1. Setting communication between the receiver and the sounder
2. Setting sounder parameters
3. Testing the sounder
Step 1: Sounder/Receiver Communication Set up
The sounder must identify itself to the system's receiver by writing its ID into
the System. Perform according to the following steps:
1. Set the receiver to the Write mode.
NOTE:
WisDom: Main Engineer menu: 9) Devices > 2)Sounder > 1)
Allocation > Select sounder> Choose INWS1
Agility: Main Engineer menu: 2) Radio Devices > 1) Allocation > 1) RF
Allocation
LightSYS (V2.40 and above): Main Engineer menu: 7) Install > 2) WL
Device > 2) Allocation > 1) By RF > 4) Sounder
2. Select the sounder's ID.
3. Unpack the supplied batteries
4. Insert two speaker batteries into the batteries chamber (Fig. 3).
5. Insert three Radio batteries into the batteries chamber.
6. After a squawk is heard you have 10 seconds to press on the tamper
switch for at least 3 seconds. If the sounder is successfully recognized,
the system will sound a confirmation beep and the sounder will initiate a
second squawk sound.
7. Repeat the process for other sounders in the system.
5
Radio
Batteries
(3V, Parallel
Connection)
Speaker
Batteries
(6V, Serial
Connection)
Tamper
Speaker
Fig. 3
Wireless Sounder Instructions