Remote Control Code Learning; Pairing With A Bluetooth Device - Monitor Audio IA40-3 Manual Del Propietário

Contents
Setting Up the IA40-3
Standby and Sleep Settings
There are two modes the IA40-3 can operate when
the Status LED is illuminated red, Standby or Sleep
mode. In Standby mode the IA40-3 can only be
turned on by pressing the Multi-Function Encoder
or through RS232 control. Setting the IA40-3 in the
sleep mode enables auto-on input signal sensing
and will turn the IA40-3 'On' when there is a signal
present and will automatically turn 'Off' when there
is no signal present for 5-7 minutes.
With the amplifier 'Off' (red Status LED) press and
hold the Multi-Function Encoder for approximately
10 seconds, or until LED starts blinking blue or green
for 3 seconds. If the Status LED blinks blue it is in
Sleep mode. If it blinks green it is in Standby mode.
To change the mode simply repeat the above.
The input switch is used for selecting between the
wired inputs. The analogue input (up position) uses
the 3.5mm wired jack input and the optical input
(downwards position) uses the wired SPDIF input.

Remote Control Code Learning

Note: This section must be completed
before any Bluetooth devices can be
paired.
1. Connect the supplied IR receiver to the
External IR port on the amplifier.
2. Connect the 33V AC power adaptor and turn
'On' the unit by pressing the Multi-Function
Encoder.
3. Press and hold the Multi-Function Endocder
on the unit it starts blinking purple (5 seconds).
Setting Up the IA40-3
Standby and Sleep Settings
Remote Control Code Learning

Pairing with a Bluetooth Device

Front and Rear Panel Layout
Status LED Guide
Fitting the Mounting Bracket
Warranty
Owner Information
FCC & IC Radiation Exposure Statement
Specifications
monitoraudio.com monitoraudio.com
4. Point any IR remote control (not supplied)
at the IR receiver and press the volume up
button 3 times, the Status LED will blink purple
3 times rapidly.
5. Repeat step 4 with the volume down button.
The Status LED will blink purple 3 times rapidly.
6. Repeat step 4 with the mute button. The
Status LED will blink purple 3 times rapidly
and then turn solid white. The amplifier is now
programmed and will respond to the remote
control volume commands.
Pairing with a Bluetooth Device
Note: Bluetooth devices cannot be
paired until a remote has been set up
with the amplifier, refer to the 'Remote Control
Codes Learning' section.
1. Turn the IA40-3 amplifier 'On' by pressing the
Multi-Function Encoder. The Status LED will
turn white.
2. Press and hold the mute button on remote
control (not supplied) for 3 seconds. The
Status LED will blink white for 1 minute or until
paired.
3. Select "IA40-3" in your Bluetooth device
settings to pair with the amplifier.
4. Bluetooth will take priority over any wired audio
signal when streaming audio. When you stop
or pause Bluetooth audio wired audio will
resume playback.
1
1
1
1
2
3
3
3
3
3
4
1 1