Monitor Audio IA40-3 Manual Del Propietário página 6

If this equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
To satisfy FCC / IC RF exposure requirements, a
separation distance of 20 cm or more should be
maintained between the antenna of this device
Specifications
Number of Output Channels
Power (W / Channel) 4 Ohms @ 1 kHz
Power (W / Channel) 8 Ohms @ 1 kHz
Input Impedance
Output Impedance (Sub/ Line Out)
Input Sensitivity
Maximum Input Voltage
Signal to Noise (SNR)
Frequency Response (+- 0.5 dB) @ 1 W
Total Harmonic Distortion
(THD+N @ 1 W, 2ch 8 Ohms, Full Bandwidth)
Dimensions Excluding Mounting Brackets and
Antenna (H x W x D)
Dimensions Including Mounting Brackets
(H x W x D)
Mains Operating Voltage
Fuse Rating (Power Supply)
Standby Power Consumption
Weight (Amp + RS232 Terminal Block + Speaker
Terminal Block + Antenna) - No Brackets
Bluetooth
Bluetooth Range with Antenna (Line of Sight)
Bluetooth Version
Bluetooth Profiles
Audio Codec
Monitor Audio reserves the right to alter specifications without notice.
4 4
and persons during device operation. To ensure
compliance, operations at closer than this distance
is not recommended.
Limited by local law regulations, version for North
America does not have region selection option.
This radio transmitter (5928A-MA439113) has been
approved by Innovation, Science and Economic
Development Canada to operate with the antenna
types listed below with the maximum permissible
gain and required antenna impedance for each
antenna type indicated. Antenna types not included
in this list, having a gain greater than the maximum
gain indicated for that type, are strictly prohibited
for use with this device.
Gain of antenna: 2dBi max.
Type of antenna: 50ohm, Omni-directionnel
60 W @ 1% THD+N for 2 Channel
40 W @ 1% THD+N for 3 Channel
50 W @ 1% THD+N for 2 Channel
30 W @ 1% THD+N for 3 Channel
180 x 110.5 x 31.4 mm
196 x 182.5 x 32.6 mm
100-240 VAC, 50/60 Hz
IA40-3 Manual IA40-3 Manual
3
10 k Unbalanced
1.47 kΩ
~300 mV - Full Power
2.3 V
> 84 dB Unweighted
10 Hz - 20 kHz
< 0.05 %
7 x 4 x 1 "
1/16 3/8 1/4
7 x 7 x 1 "
11/16 3/16 5/16
3 A
< 0.5 W
0.484 kg
1 lb 2 oz
Yes
> 20 m
4.1
A2DP, AVRCP
SBC, Apt-X