Pause; Flash Time; Music On Hold; Memory Programming - Spiker TP1 Manual De Usuario

User manual Spiker TP1

PAUSE

Press the button will cause a time delay of 3.6s before dialing.

FLASH TIME

Press the button to reset the line without leaving the handset. The default setting is 100ms.
The user can change the flash time in the MENU mentioned above.

MUSIC ON HOLD

To put the engaged party on hold, press the "Hold" button once and place the handset back on the cradle.
Then, the other party will hear a melody tone. The music will be played from the speaker to remind you that
the call is still on hold. Lift the handset or just press
conversation
There are 5 music for you selection, which is changed with your selected polyphonic music.

MEMORY PROGRAMMING

There have 10 indirect memories, which can be stored
1. In standby mode press the
2. Press then "1" to store the telephone number in memory "1" location
3. Repeat the above sequence to store telephone numbers in 0, 2,3,4,5,6,7,8,9
VIEW & DIAL OUT INDIRECT MEMORY
There have 10 indirect memories, which can be view and dial out in On-hook State or just dial out
in off-hook
Dial out the indirect memory
1. Pick up the handset or press
2. Press button once, then select a memory location "0.9"
3. The stored number will dial out automatically.
-
In standby mode, you can,
- Press button once, then select a memory location "0.9".
- Press button, the unit will activate the speaker phone automatically and dial out the number.

CHECK INCOMING CALLER LIST

The unit can store up to 35 records of incoming caller list & each can be viewed by the following
procedures:
1. Press ? button once the LCD will show the final received record
2. Press ? / ? button once to view other record
3. Press the hook switch once or jut wait for the time out to quit.
button once to release this function and resume your
button once and enter the desired telephone number.
button once to engage the line
32