Operation; Cooling; Dehumidifying; Fan - Jocel JACP-010 Manual De Funcionamento

OPERATION

Plug the power cord into a properly grounded outlet. Do not connect the unit to an
outlet that is also being used for other electrical appliances. The unit will beep
after seconds, and then press the on/off button to begin operation.

COOLING

1. Press the Mode Button to choose the cooling
2. To adjust the temperature, press the Temperature buttons one or more times until the
required temperature is displayed. Possible temperatures are between 18ºC and
30ºC inclusive.
3. Press the Fan Speed Button to choose the desired fan speed.
4. Press the Swing Button to select a steady airflow or oscillation.
 In order to improve cooling efficiency, draw the curtains in a room exposed to direct
sunlight.
 Do not place near a heat source.

DEHUMIDIFYING

1. Press the Mode Button to choose the dehumidifying
 In the Dehumidifying Mode, the fan speed cannot be adjusted.
 When the unit is used as a dehumidifier only, do not use the exhaust duct.
 Keep the windows and doors closed to aid in effectively dehumidifying the room.

FAN

1. Press the Mode Button to choose the fan
2. Press the Fan Speed Button to choose the desired fan speed.
3 Press the Swing Button to select a steady airflow or oscillation.

HEATING

1. Press a tecla Modo to choose the Heating
2. To adjust the temperature, press the Temperature buttons one or more times until the
required temperature is displayed. Possible temperatures are between 18ºC and
30ºC.
3. Press the Fan Speed Button to choose the desired fan speed.
4. Press the Swing Button to select a steady airflow or oscillation.
 When the room temperature is below 7ºC, heating function will not start.
Note: If the air conditioner is turned off, wait 3 minutes before restarting. This
allows pressure inside the compressor to equalize. Failure to allow these
instructions may cause inefficient operation.
All manuals and user guides at all-guides.com
-32-
function.
function.
function.
function.