Before Starting The Engine - Briggs & Stratton ELITE Serie Manual Del Propietário

Ocultar thumbs Ver también para ELITE Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

6.
Slide the axle through until wheel is tight against
bracket.
7.
Install the e-ring on the other side in the same manner
as steps 4 & 5. Remove the wooden blocks.
8.
Attach the vibration mount to the support leg with a
30mm capscrew and lock nut.
9.
With the wheels on, secure the support leg assembly
to the cradle with 20 mm long capscrews, flat washers,
and lock washers.
10. Check that all fasteners are tight and the tires are inflated
to the value marked on the tire or within 15 and 40 psi.
Check Battery / Attach Negative
Battery Wire
The sealed battery on the generator is fully charged and
pre–installed except for the negative (black) battery cable.
To install:
• Cut off tie wrap securing loose end of negative (black)
cable.
• Remove nut and washer on the negative battery terminal.
• Slide the negative battery cable over the screw on the
negative terminal (Figure 2).
Figure 2 — Negative Battery Connection
Negative
Battery Cable
• Reattach washer and nut and tighten.
• Verify that the connections to the battery and generator
are tight and secure.
10000W Generator
BEFORE STARTING THE
ENGINE
Add Oil
CAUTION!
before it has been properly filled with the recommended
oil may result in an engine failure.
To fill your engine with oil:
• Place generator on a level surface.
• Follow the oil grade recommendations and oil fill
instructions given in the engine owner's manual.
NOTE: The generator assembly rotates on a prelubricated
and sealed ball bearing that requires no additional
lubrication for the life of the bearing.
Add Fuel
WARNING!
fill fuel tank when engine is running or hot.Allow unit
to cool for two minutes before refueling. DO NOT
light a cigarette or smoke when filling the fuel tank.
WARNING!
Always allow room for fuel expansion.
• Place generator on a level surface.
• Follow the fuel grade recommendations and fuel fill
instructions given in the engine owner's manual.
7
Any attempt to crank or start the engine
NEVER fill fuel tank indoors. NEVER
DO NOT overfill the fuel tank.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

09801

Tabla de contenido