Troubleshooting - Briggs & Stratton ELITE Serie Manual Del Propietário

TROUBLESHOOTING

Problem
No AC output is available,
but generator is running.
Generator runs good at
no-load but "bogs" down"
when loads are connected.
Generator will not start;
or starts and runs rough.
Generator shuts down
during operation.
Generator lacks power.
10000W Generator
Cause
1. One of the circuit breakers is open.
2. Fault in generator.
3. Poor connection or defective cord set.
4. Connected device is bad.
1. Short circuit in a connected load.
2. Generator is overloaded.
3. Shorted generator circuit.
1. Fuel Valve is in the "Off" position.
2. Failed battery.
Out of gasoline.
Load is too high.
Correction
1. Reset circuit breaker.
2. Contact Authorized service facility.
3. Check and repair.
4. Connect another device that is in
good condition.
1. Disconnect shorted electrical load.
2. See "Don't Overload Generator" on
page 13.
3. Contact Authorized service facility.
1. Turn fuel valve to the "On" position.
2. Replace battery.
Fill fuel tank.
See "Don't Overload Generator" on page
13.
15