Crivit Sports 1-LD3814 Manual De Instrucciones página 14

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Chest belt
Operating temperature
Dimensions
Frequency
Weight
Battery
Features
Heart rate measurement
Alarm for maximum heart rate
Target heart rate training with timer and alarm
(Health, Fitness, Peformance and user defined)
Max. heart rate, min. heart rate and average heart rate
Warning light for high heart rate
Calorie features
Calories and fat burned during training
BMI-calculation
Fitness Level
Stop watch
1/100 seconds with 99 lap times
Countdown timer
Time features
Time
Calendar
Alarm with snooze
Hourly chime
Second time zone
Setup of the heart rate monitor
Use a coin to unscrew the battery cover on the back side of the chest belt and
insert the 3V battery with the (+) sign facing up. Screw the battery compartment
cover back into the case.
Remove the protective film from the display and press MODE, SEL or SET.
Now select English, German, French or Spanish language by pressing SEL and
confirm your setting by pressing SET.
Select the unit KM-KG
METRIC
KM - KG
or Miles/pounds
IMPERIAL
M - LB
in the same way. Complete the setting procedure by pressing MODE.
All manuals and user guides at all-guides.com
0-50°C
7 x 3,3 x 1,2 cm
110 kHz
51g
CR 2032/3V
 - 51 -
battery CR2032
KM - KG
KM - KG
M - LB
M - LB
 - 53 -
Other
Back light
Important safety information
ATTENTION: Consult your doctor before you begin any
training program. Your doctor can help you choose the
proper training intensity and heart rate guidelines for your
exercises.
This heart rate wrist watch is not a medical device and should
only be used as a guide for your training.
- Batteries
Insert the batteries/ rechargeable batteries in the correct polarity. Don't try to
recharge non-rechargeable batteries and under no circumstances throw them into
fire. Danger of explosion.
Do not use unequal batteries (old and new, Alkaline and carbon, etc.)
simultaneously. If you will not use the device for a long time, remove the batteries
and store the device in a dry and dust-free place. Improper use of batteries may
cause an explosion or leakage. If the batteries have leaked, use gloves and clean
the appliance thoroughly with a dry cloth.
- Electrical devices should not be in the hands of children
Never let children use electrical devices unsupervised. Children can't always
recognize the possible dangers properly. Batteries/ rechargeable batteries can
be life threatening when swallowed. Store the batteries where they cannot be
reached by small children. If a battery is swallowed, medical aid must be sought
immediately.
Also keep the packaging foils away from children. Danger of suffocation.
Reset
The watch can be reset by pressing and holding SET and SEL together. Only after
reseting the watch the other language can be selected.
Replacing the watch battery
The battery replacement can be performed by a watch maker in addition to a
water resistance test.
To replace the battery yourself, please read the following instructions first:
Remove the screws (1, 2, 3 and 4) from the back side of the watch with a small
Phillips screwdriver. Remove the caseback and the battery sticker.
Use a small, flat tool to open the latch (5) of the battery holder. Remove the
battery and insert a fresh 3V CR2032 battery with the (+) terminal facing upwards.
Ensure that the gasket (6) is seated correctly. Close the latch of the battery holder.
Replace the battery sticker and the caseback and replace the screws.
Battery low indicator
If the battery voltage on the chest belt battery drops below the voltage required for
normal operation,
TXBELT
TXGURT
LO BAT
BATT
will appear on the display. Replace the battery of the chest belt as described in the
chapter "Chest belt".
 - 52 -
SNGLTX
TXBCIN
PILE
BAT BA
 - 54 -

Publicidad

Tabla de contenido
loading

Tabla de contenido