Tabla de contenido
Publicidad
•
B. This equipment returns answer supervision on all DID calls forwarded to the PSTN. Permissible
exceptions are:
•
•
•
Canada Class A Warning
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numèrique de la classe A est conforme á la norme NMB-003 du Canada.
Equipment Attachment Limitations
The Industry Canada label identifies certified equipment. This certification means that the equipment
meets certain telecommunications network protective, operational, and safety requirements as
prescribed in the appropriate Terminal Equipment Technical Requirement Documents. The Department
does not guarantee the equipment will operate to the user's satisfaction.
NOTICE: This equipment meets the applicable Industry Canada Terminal Equipment Technical
Specifications. This is confirmed by the registration number. The abbreviation, IC, before the
registration number signifies that registration was performed based on a Declaration of Conformity
indicating that Industry Canada technical specifications were met. It does not imply that Industry Canada
approved the equipment.
Before installing this equipment, users should ensure that it is permissible to be connected to the
facilities of the local Telecommunications Company. The equipment must also be installed using an
acceptable method of connection. In some cases, the companies inside wiring associated with a single
line individual service may be extended by means of a certified connector assembly (telephone extension
cord). The customer should be aware that compliance with the above conditions might not prevent
degradation of service in some situations.
Repairs to certified equipment should be made by an authorised Canadian maintenance facility
designated by the supplier. Any repairs or alterations made by the user to this equipment, or equipment
malfunctions, may give the telecommunications company cause to request the user to disconnect the
equipment.
Users should ensure for their own protection that the electrical ground connections of the power utility,
telephone lines, and internal metallic water pipe system, if present, are connected together. This
precaution may be particularly important in rural areas.
Users should not attempt to make such connections themselves, but should contact the appropriate
Caution
electrical inspection authority, or electrician, as appropriate.
The Ringer Equivalence Number (REN) for this terminal equipment is 1. The REN assigned to each
Note
terminal equipment provides an indication of the maximum number of terminals allowed to be connected
to a telephone interface. The termination on an interface may consist of any combination of devices
subject only to the requirement that the sum of the Ringer Equivalence Numbers of all the devices does
not exceed five.
OL-10259-02
All manuals and user guides at all-guides.com
Routed to a dial prompt
A call is unanswered
A busy tone is received
A reorder tone is received
Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Regulatory Compliance and Safety Information
Agency Compliance
7
Publicidad
Tabla de contenido
