Cisco 2600 Serie Manual Del Usuario página 4

Agency Compliance
If this equipment causes harm to the telephone network, the telephone company will notify you in
advance that temporary discontinuance of service may be required. If advance notice is not practical, the
telephone company will notify the customer as soon as possible. Also, you will be advised of your right
to file a complaint with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operation, or procedures that
could affect the operation of this equipment. If this happens, the telephone company will provide
advance notice in order for you to make the necessary modifications to maintain uninterrupted service.
Normally, this equipment will be used in conjunction with FCC registered equipment that limits the
Encoded Analog Content that provides the required Billing Protection. If the connected equipment is not
of this type, an affidavit must be supplied to the telephone company where the network connection is to
be made. The affidavit is to be notarized, and is to be filed at least ten days before the initial connection.
The facility interface and service order codes are shown in
Cisco 2600 series, 3600 series, and 3700 series routers bearing labeling identification number
5B1USA-27857-MF-E comply with the following requirements:
FCC Rules and Regulations 47 CFR Part 68
•
TIA/EIA/IS-968, Technical Criteria for Terminal Equipment to Prevent Harms to the Telephone
•
Network, July 2001, as adopted by the Administrative Council on Terminal Attachments (ACTA)
See Figure 1 on page 6
online at http://www.cisco.com/warp/customer/508/dofc/163898.pdf.
Table 2
Interface Type
1
ADSL
SHDSL
BRI-S/T
BRI-U
T1 data
T1 voice
1
FXO
CAMA
DID (Reverse battery)
E&M tie trunk
Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Regulatory Compliance and Safety Information
4
All manuals and user guides at all-guides.com
for Cisco's Supplier Declaration of Conformity. This document is also available
Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers Facility Interface and
Service Order Codes
Facility Interface Code (FIC)
Metallic
Metallic
02IS5
02IS5
04DU9-BN
04DU9-DN
04DU9-1KN
04DU9-1SN,
04DU9-BN
04DU9-DN
04DU9-1KN
04DU9-1SN,
04DU9-1ZN
02LS2
02GS2
1
02RV2-0
02RV2-T
TL11E
TL12E
TL31E
TL32E
Table 2.
Service Order
Code (SOC) Jack Type (USOC)
— RJ-11C
— RJ-11C
6.0N RJ-49C via NT1
6.0N RJ-49C
6.0N RJ-48C
6.0Y RJ-48C
— RJ-11C
RJ-21X
— RJ-11C
AS.2 RJ-11C
9.0F RJ-2EX
RJ-2FX
RJ-2GX
RJ-2HX
OL-10259-02