Electro - Magnetic Compatibility Information; Electro-Magnetic Emissions; Technical Maintenance - Medit i500 Manual Del Usuario

5
Safety Guide
5.10 Protection from overheating
WARNING
▪ Do not block the air vents located at the rear of the i500 system. If the equipment
overheats, the i500 system may malfunction or stop working.

5.11 Technical Maintenance

CAUTION
▪ Equipment maintenance should be carried out only by a MEDIT employee or a
MEDIT-certified company or personnel.
▪ In general, the user does not need to perform maintenance work on the i500 system
except for calibration, cleaning, disinfection and sterilization. Preventive inspections
and regular maintenance are not required.\
6
Electro – Magnetic Compatibility Information

6.1 Electro-Magnetic Emissions

This EUT is intended for use in the electromagnetic environment as specified
below.
The customer or the user of the EUT should ensure that it is used in such an
environment.
RF Emissions CISPR 11 – Group 1
The EUT uses RF energy only for its internal functions.
Therefore, its RF emissions are very low and are not likely to cause any
interference in nearby electronic equipment.
RF Emissions CISPR 11 – Class A
The EUT is suitable for use in all establishments, including domestic
establishments and those directly connected to the public low-voltage power
supply network that supplies buildings used for domestic purposes.
Immunity Test Compliance
Harmonic emissions
IEC 61000-3-2 A
Voltage fluctuations/
Complies
Flicker emissions
Electromagnetic
Environment - Guidance
The EUT is suitable for use in all establishments,
including domestic establishments and those
directly connected to the public low-voltage
power supply network that supplies buildings
used for domestic purposes.
The EUT is suitable for use in all establishments,
including domestic establishments and those
directly connected to the public low-voltage
power supply network that supplies buildings
used for domestic purposes.
Intraoral Scanner i500 19