Product Installation; First Use; Placing The Water Tank - SPC BAAMBA GYRO PRO SUCTION 4400 Manual De Instrucciones

2. PRODUCT INSTALLATION

2.1 FIRST USE

Connect the power cable to the charging base, respecting the recommended distances. The robot
can also connect directly to the power cable through the socket in its side.
Turn the robot on using the side switch. If it does not turn on, check that the battery is connected by
removing the two screws on the rear cover. Once checked, place the robot on the charging base by
lining up the electrodes and checking that the light comes on; if it does not, leave it to charge for 4-6
hours. Attach the lateral brushes that are included in the box, matching them to the letters on the robot.
The robot cannot be turned off while it is charging. If you need to turn it off, remove it from the
charging base and turn it off using the switch.

2.2 PLACING THE WATER TANK

Remove the dust box by pressing the button and
sliding it out of the robot.
Insert the water tank by pushing it into the robot
until you hear a click.
Advice:
• Do not use the water tank when using the cleaner for the first time.
• Do not use the robot's water tank if you will not be observing it.
• Do not leave the tank installed in the robot unless it is working.
• Remove the water tank before recharging the robot.
• If there are carpets in the home, remove them before starting the cleaning, or make virtual walls
using the magnetic tape.
• Avoid using cleaning products because they can clog the water outlets.
• When the cleaning has finished, remove the mop, clean it and allow it to dry before using it again,
clean the dust box with a cotton cloth and then check that the solenoid valve contacts are
completely dry.
EN