Troubleshooting And Frequently Asked Questions - SPC BAAMBA GYRO PRO SUCTION 4400 Manual De Instrucciones

6. TROUBLESHOOTING AND FREQUENTLY ASKED QUESTIONS

When the indicator light flashes red or you notice something wrong, you can try to solve the problem
by checking the table below:
If you do not find your problem, please contact our technical service by calling +34 944 580 178.
PROBLEM
The robot does not move
The robot does not detect a
step
The robot hits something and
does not change direction
The temperature of the robot is
too high or low
It does not charge, or the
battery does not fully recharge
The compartment does not fit
inside the robot
The robot does not turn on or
returns to the charging base
very soon after starting
cleaning.
Fault when starting to clean
The robot does not reach the
charging base
Unusual movements
Check that the brushes are not blocked and there is no object in front
of the robot, place it on the charging base and check that the indicator
lights up. Move the robot to a new location and press the button to
start cleaning.
Clean the anti-fall sensors with a cotton cloth; check there is no dirt
on them, then press the button to start cleaning again.
Check that nothing is blocking the shock sensor; it must move a little
for the sensor to work.
Stop the robot and leave it to rest until it returns to its normal
temperature.
Check that there is good contact between the robot's electrodes and
those of the charging base; if there is, check that the electrodes are
not dirty; if there is dirt, clean them with a cotton cloth (unplug the
charging base before cleaning it).
Check that the HEPA filter is fitted correctly; if it is, check that
the spring at the end can move when the filter is fitted.
The battery is too low, place it on the charging base and check that
the indicator lights up.
The ambient temperature is too low (<0ºC) or too high
(>50ºC).
The battery is too low, place the robot on the charging base and wait
for it to charge.
There are too many obstacles before the charging base. Clear the
area near the base and respect the distances required. Check that
the charging base is correctly connected to the mains energy
supply.
Turn the robot off and on again using the switch. Return to the default
parameters using the SPC IoT application.
SOLUTION
EN