intensity TWIN STIM III Manual De Instrucciones página 25

All manuals and user guides at all-guides.com
2) Set Timer
Press [S] button cycle to enter this setting. The treatment time is
adjustable from 1 – 60 minutes or Continuous. Press [▲] or [▼]
control to adjust setting. You can set the timer to "Continuous" mode
by pressing the [▲] button when it shows 60 minutes. The output
will be shut off when time is up.
3) Set Pulse Width
The pulse width determines the length of time. Each electrical
signal is applied through the skin, which controls the strength and
sensation of the stimulation. Press [5] button cycle to enter this
setting. The pulse width is adjustable from 50 – 300 p5.
Press [▲] or [▼] button to adjust the
4) Set Pulse Rate
The pulse rate determines how many electrical impulses are
applied through the skin each second. Press [S] button cycle to
enter this menu. By pressing the [▲] or [▼] button to adjusting the
setting. The pulse rate is adjustable from 1 Hz – 150 Hz.
5) Set Delay Time (Optional)
Delay time is adjustable from I to 10 seconds.
Only Delay therapeutic program has this
parameter setting. Press [S] button cycle to
enter this menu, and then press the [▲] and
[▼] button to adjusting the setting.
6) Set Ramp Time
The ramp time controls the time of output current that increase from
0 to the setting level, and from the setting value to 0
When the ramp time is set, each contraction may be ramped up and
down in order that the signals come on and come off gradually and
smoothly. The ramp time is adjustable from 1 – 6 seconds.
7) Set Contract Time
The contract Time controls the time of stimulation. The contraction
time can be adjusted. Press [S} button cycle to enter this menu, and
then press the [▲] and [▼] button to adjusting the setting. Both
channels' stimulation is cycled on and off by the contraction and
relaxation settings. The range is adjustable from 1 – 60 seconds.
25