Technical Data - Crown CT38106 Manual Del Usuario

IMPORTANT
Read all safety rules and operating Instructions carefully before first use it. Keep this Manual for
future reference.
I. Technical data
1 Fastener
CT38106
Fastener size: 18gauge(1.25x1.00mm)
Nail length: 15-50mm (19/32"- 2")
Magazine capacity:100pcs
CT38107
Fastener size: Drives18Ga Brad Nails 19/32"~2" and 18Ga Crown staples 5/8"~1-37/64".
Crown : 5.7mm(7/32").
Nail capacity: 100pcs
2 Accessories
Hexagon Key
Lubricant
Operating instruction
English
1
3 Description/Features
CT38106:
New-type magazine pressing button, fast and easily loading of nails.
Die-cast alum. Body for strong power and light weight.
360 degree adjustable air deflector.
Rubber grip handle for reducing the fatigue of operator.
CT38107:
2 in 1 Combi nailer: Magazine design,shoot both 18Ga. Brads and 18Ga.Staples, Touch strike security
system is safe for the operator,Tool free depth control
to control the nails depth.
4 location of Parts (see Figure 1 and 2)
CT38106
A-Magazine
B-Safety Yoke
C-Trigger
D-Magazine Latch
E-Air Quick Coupler
F-Exhaust Vent
G-Quick release handle
CT38107
A-Magazine
B-Magazine Latches
C-Safety Yoke
D-Trigger
E-Exhaust Vent
F-Air Quick Coupler
II. Special references
1 Instructions
The following standard is applicable to fastener driving tools; EN792-13:2000+A1:2008
"Hand-held non-electric power tools-safety requirements – Part 13: Fastener driving tools".
This standard requires that
1、Only those fasteners which are specified in the operating instructions (see TECHNICAL DATA)shall
be used in fastener driving tools. The fastener driving tool and the fasteners specified in the operating
instructions are to be considered as one unit safety system;
2、Quick action couplings shall be used for connection to the compressed air system and the
non-sealable nipple must be fitted at the tool in such a way that no compressed air remains in the tool
after disconnection;
3、Oxygen or combustible gases shall not be used as an energy source for compressed air operated
fastener driving tools;
4、Fastener driving tools shall only be connected to an air-supply where the maximum allowable
pressure of the tool cannot be exceeded by more than 10%;in the case of higher pressure ,a
F
Fig. 1
C
G
A
B
E
Fig. 2
D
C
English
2
E
D
F
B
A