Appendix A: System Messages - MediCapture MediCap USB100 Guia Del Usuario

MediCap™ USB100 User Guide

Appendix A: System Messages

ALERT! Internal Memory is FULL
Description: Images are captured to internal memory, but when
you see this message, you cannot capture any more images
because the internal memory is full.
Action: Select the "Save images to USB" menu choice at the
bottom of the screen (to do so, use the Back, Next, and Select
buttons on the front panel). This will copy the images to the USB
flash drive. Then you can clear the internal memory to make more
room for capturing images. See the "Clearing Internal Memory"
section on page 13.
ALERT! USB memory NOT sufficient
Delete some images
or insert new USB memory
Description: This message will be displayed after you press the
Save to USB Memory button, and the system has determined that
there is not enough memory available in the USB flash drive to hold
the images that it is trying to copy from internal memory to the flash
drive.
Action: Remove the USB flash drive from the front panel and insert
it in a Windows computer (98, ME, NT, 2000 or XP required). Follow
the procedures described on page 14 to transfer any images on the
flash drive to your computer and then clear the memory on the flash
drive. Then you can re-insert the flash drive in the front panel of the
USB100 and press the Save to USB Memory button again.
If the flash drive still does not have sufficient memory, you will need
to delete some images from internal memory by using the Review
Images and Delete buttons on the MediCap USB100 front panel.
16 USB100-UG-E-070324-MC