Introduction; Ordering Information; Technical Support - MediCapture MediCap USB100 Guia Del Usuario

Introduction

The MediCap™ USB100 allows you to easily capture digital medical
images from virtually any analog medical imaging device that has
standard BNC or S-Video output.
To get started, connect the USB100 as shown on page 8 and insert
a MediCapture brand USB flash drive into the front panel. Then use
your medical imaging device as you normally do. When you see an
image on your monitor that you would like to capture, press the
Capture Images button to save the image. You can continue
pressing the Capture Images button to save more images.
When you are done with your imaging session, press the Save to
USB Memory button to save all the images onto the USB flash
drive. Then you can remove the flash drive and insert it in a
Windows computer that has a USB connection. The MediCapture
Image Transfer wizard will help you transfer the images onto your
computer. You can then take full advantage of the power of digital
imaging; you can view your images, archive them, share them on a
network, email them, and so on.

Ordering Information

The MediCap™ USB100 requires MediCapture™ brand
USB flash drives available from MediCapture dealers (flash
drives from other manufacturers are not compatible with the
USB100). To locate a MediCapture dealer, please visit the
"Buy" web page at www.medicapture.com.

Technical Support

For technical support and other questions, please visit
MediCapture's web site at www.medicapture.com or call
888-922-7887 (toll free from within the USA) or 503-445-
6935 (from outside the USA).
MediCapture Inc.
580 West Germantown Pike, Suite 103
Plymouth Meeting, PA 19462 USA
MediCap™ USB100 User Guide
5 USB100-UG-E-070324-MC
To get started quickly
with your USB100,
review the front panel,
back panel, and
connections diagrams on
the following pages and
then refer to the "Quick
Start Guide" on page 8.