Function Buttons I And; Horn; Armrests - MINOS POWER Manual De Uso Y Mantenimiento

This setting can be adjusted using the Function buttons I and II. For an explanation, see section
5. Function buttons
5. Function buttons I and II
Use these function buttons to set the minimum and maximum speed. You can increase the speed
by pressing function button II a number of times. You can then reduce the speed by pressing
function button I a number of times. There are 4 possible settings for speed.

6. Horn

By pressing this button you can make a sound signal. You steer the wheelchair by moving the
joystick in the required direction. Push the joystick forwards and the MINOS POWER moves for-
wards... move the joystick a little to the left or right and the MINOS POWER will immediately
move in that direction... all movements should be smooth and steady, without jolts or sudden
movements. Driving backwards? If you want to move backwards, move the joystick towards you.
To stop? The MINOS POWER stops immediately as soon as you release the joystick!
Caution: When getting in and out of the wheelchair or when transferring to or from the wheelchair, always
turn off the electronics This prevents accidentally touching the joystick and moving the MINOS POWER

6. ARMRESTS

Warning: Do not lift or carry the Minos Power by the armrests!
Armrest
To remove the armrests, first press the button (see figure 5/
armrest can remain in this position until you want to get in or out of the wheelchair. You can remo-
ve the armrest by turning it until the bolt is loosened, after which you can lift it up.
You can adjust the height of the armrest. To do this, use allen key 3 and spanner 8 to loosen the fas-
➀
tening bolt (figure 7/ ) and pull the armrest upwards until it is at the correct height. Then tighten
the screw again.
Warning: After assembling and adjusting, make sure that the bolt is securely tightened again.
➀
FIGURE 5
➀
) and pull the armrest backwards. The
➀
FIGURE 6
➀
FIGURE 7
31