Vimar ELVOX EMC.W Guía Rápida Para El Instalador página 8

EMC.W
Status
Access point configuration:
SSID Vimar_D33A8C
Channel 11 ▼
P1
x n
Security WPA-PSK ▼
••••••••••
Password
(8-63 Characters)
IP address 192.168.1.1
IP netmask 255.255.255.0
DHCP
DHCP range: 192.168.1.2
DL1 DL4
DL5
JP3
DL1 DL4
DL5
JP3
Apply
DL1 DL4
DL5
JP3
Parameter Values
SSID Free choice
Channel 1 to 11
OPEN:
Security
WPA-PSK
P1
x n
Password Free choice
IP address Not modifiable
Not
IP netmask
modifiable
DHCP
DHCP Not
DL1 DL4
DL5
JP3
range modifiable
DL1 DL4
DL5
JP3
DL1 DL4
DL5
JP3
Note:
The Wi-Fi module accepts only one connection at a time, if you try to connect from more than one device the module
will refuse the connection of the second device attempting to connect.
The module may also be configured in "Station" mode to connect to an existing Wi-Fi network. This mode is not imple-
mented at Wi-Gate app operating level.
It is recommended to always run the module in "Access Point" mode.
6
Station
Description
Name of Wi-Fi network generated by the module.
For the purpose of recognition, you are advised to leave the default name as this
refers to what printed on the label applied to the module.
Communication channel used.
In case of need due to a disturbed signal, using a third party app it is possible to find
out the names of the routers nearby, the occupied channels and the signal intensity,
and consequently choose a free radio channel to obtain a better connection.
No security (anyone may connect to the network).
WPA protection (Wi-Fi Protected Access Pre Shared Key).
Password required to access the Wi-Fi network generated by the module. The
password must contain letters and numbers (no special characters) and must have
between 8 and 63 characters.
Module IP address.
Method used to define the address range of a host in an IP subnet.
The Wi-Fi module acts as DHCP server (setting not modifiable), the module
automatically assigns the IP addresses to the connecting devices.
Range of IP addresses assigned by the module when configured as DHCP server.
Not modifiable as the module accepts only one connection at a time.
EN