ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Blade diameter
Hole diameter
Max. kerf thickness of the saw blade
Max. miter angle
Max. bevel angle
No load speed (RPM)
Dimensions (L x W x H)
Rated voltage
Net weight
Cutting capacities (H x W)
45° (right and left)
60° (right and left)
Cutting capacities for special cuttings
Type of cutting
Crown molding 45° type
(with crown molding stopper used)
Base board
(with horizontal vise used)
•
Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
•
Specifications may differ from country to country.
•
The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
•
Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Miter angle
0°
805 mm x 644 mm x 660 mm
(31-3/4" x 25-3/8" x 26")
D.C. 36 V - 40 V max
45° (left)
47 mm x 305 mm
(1-7/8" x 12")
61 mm x 279 mm
(2-3/8" x 11")
47 mm x 215 mm
(1-7/8" x 8-1/2")
61 mm x 197 mm
(2-3/8" x 7-3/4")
-
* : Recommended battery
2 ENGLISH
LS004G
255 mm (10")
15.88 mm (5/8")
3.2 mm (1/8")
Right 60°, Left 60°
Right 48°, Left 48°
3,600 /min
26.6 - 27.2 kg
(58.6 - 60.0 lbs)
Bevel angle
0°
45° (right)
71 mm x 305 mm
29 mm x 305 mm
(2-13/16" x 12")
(1-1/8" x 12")
91 mm x 279 mm
43 mm x 279 mm
(3-5/8" x 11")
(1-11/16" x 11")
71 mm x 215 mm
29 mm x 215 mm
(2-13/16" x 8-1/2")
(1-1/8" x 8-1/2")
91 mm x 197 mm
43 mm x 197 mm
(3-5/8" x 7-3/4")
(1-11/16" x 7-3/4")
71 mm x 152 mm
(2-13/16" x 6")
91 mm x 139 mm
(3-5/8" x 5-1/2")
Cutting capacity
168 mm
(6-5/8")
133 mm
(5-1/4")
BL4025 / BL4040*
DC40RA
-