Calling Up Vehicle Information - Hella Gutmann mega macs 56 Guía De Instalación Rápida

Working with the Device

Calling Up Vehicle Information

2. Select >Diagnostics< in the main menu.
CAUTION
Pulling off of the DT VCI when actuating the clutch
Risk of injury or material damages
Proceed as follows before startup:
1. Apply the parking brake.
2. No gear is engaged.
3. Regard the window with information and instructions.
NOTICE
Danger of short circuit and voltage peaks when connecting the DT VCI
Danger of destruction of automotive electronics
Switch off ignition before connecting the DT VCI to the vehicle.
3. Insert the DT VCI into the vehicle's diagnostic port.
Both LEDs of the DT VCI flash. The DT VCI is ready for operation.
to select the desired diagnostics under Function, Assembly and System.
4. Use
5. Observe the information window, note window and instruction window as applicable.
6. Start the communication with
The diagnostic procedure between the device and the DT VCI takes place via Bluetooth.
Connection to the DT VCI is established if the symbol
7. Repair the vehicle. Then delete the saved trouble codes from the vehicle system.
7.3 Calling Up Vehicle Information
Here you have an overview of the vehicle information including the following:
• Car History
• Component Help
• Service data
NOTE
You require an online connection if you wish to access all available information.
Proceed as follows to call up vehicle information:
1. Select >Vehicle information< in the main menu.
2. Select the desired type of information using the symbols.
Certain types of information may not be available depending on the selected vehicle.
.
changes from black to green.
mega macs 56
EN
45