NEO ION 715Z Manual De Usuario página 12

5. DMX CONNECTION AND DMX PROTOCOL
DMX addressing
The device is controlled by universal DMX 512 pro-
tocol, DMX address is the start channel used to re-
ceive instructions from the external controller. For
independent control, each fixture must be assigned
its unique address control channels. For example,
this device has four channel modes: 19/50/18/20,
if we set the mode at standard 19 channels mode,
and there are several models need to be inde-
pendently controlled, we just simply address first
fixture at 1, and second fixture at 20, third one at
39, etc.
If the devices have the same address, they will
behave synchronically. DMX addressing is limited,
don't set the address so high that without enough
control channels for the fixtures.
Display is flashing when no DMX signal is received.
Connection: use DMX cable with 3-pin XLR-plugs
to connect the controller with the fixture or one
fixture with another.
P. 12
Neo ION 715Z -
English version
This device is equipped with 3-pins DMX in and
out sockets only.
Pin 1 = GND | Pin 2 = Signal (-) | Pin 3 = Signal (+) |
The termination is prepared by soldering a 120Ω
resistor between pins 2 and 3.