Adjusting The Sanding Drum Drive Belt; Replacing The Conveyor Belt - Holzmann ZS640P Manual De Instrucciones

13.7
The drum is driven by one belt and powered by the main motor. If the belt become too loose,
remove the right end guard, front guard, and then adjust the position of the motor (height) by
turning the M12 nuts on the height adjustment bolts (See figure). (for model：DS-
25、26、380、38A、13、13A)
If the motor becomes damaged and needs to be replaced, remove the bolts on the bottom of the
motor base plate, and remove the entire motor assembly.
13.8
If the conveyor belt becomes too worn, the workpiece will not be fed effectively. To replace the
conveyor belt, remove the guards at both ends of the sander, and remove the four fix screws at
the bottom of the feed table assembly. The feed table can then be removed so that the feed belt
can be replaced. (See figure)
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at

Adjusting the sanding drum drive belt

Replacing the conveyor belt

Screws
Nuts
Height Adjustment
Bolt
5/16" nut
Lijadora de rodillos / mini wide belt sander ZS640P/ZS970P
Página 29