Maintenace - Holzmann ZS640P Manual De Instrucciones

15

MAINTENACE

NOTE
Before performing any maintenance or lubrication, disconnect the machine from the power
source.
1. The table height adjustment screw shafts located at either end of the machine must be well
lubricated with grease.
2. Make sure all nuts and screws are tight before sanding. Check that the sanding belt is
mounted properly, and have not become loose or torn.
• Disturbances or defects which can affect the security of the machine allow to immediately
remove.
• The entire and regular cleaning of the machine guarantees a long life span and shows a
security condition. Use exclusively mild cleaning agents, i.e. no petrol, paraffin, soda etc.
...
• Check regularly whether the warning tips and security tips are in the machine available
and in perfectly legible state
• Check before every company the flawless state of the security facilities.
• With storage of the machine this may not be kept in a humid space and must be protected
against the influence by weather terms.
• Control all screw combinations on firm seat every week
• Your specialist supplier does the removal of defects
• Repair operations may be carried out only by specialist staff
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
Do not allow excessive dust to accumulate on or in the machine.
With cleaning and maintenance with connected machine:
Damages to property and heavy injuries(violations) by uninten-
tional turning on of the machine possibly!
Therefore:
Before servicing works switch off machine and from that
Tension care separate
W A R N I N G
Lijadora de rodillos / mini wide belt sander ZS640P/ZS970P
Página 31