Bellelli B-FIX Manual De Instrucciones página 16

EN EN
not properly attached. Furthermore, after tightening and covering the mounting support, the screws
may only emerge slightly (see fig. E).
Position the mounting support (7) on the bicycle frame and make sure that the two openings which
are meant for the support fork are placed upwards.
WARNING: Do not attach the mounting support to the handlebar.
WARNING: Align the mounting support in the direction of travel (yellow button aligned towards the
front part of the bicycle).
Screw the nuts slightly and evenly on (fig. D). The mounting support must be able to rotate freely
around the bar, in so far as it is consistent with the shape of the bike frame. The definitive fixing takes
place after the correct position for the seat is set (as is shown in the following section "Assembly of
the seat on the bike").
WARNING: Check that the mounting support does not interfere with the break and gear shift cables.
Safety System / Theft Protechtion
The mounting support is equipped with a security system/theft protection, which can be operated
with a key (5) that is operates with the equipment.
If the system is in the closed position, it is not possible to insert the support fork of the seat in the
bracket or pull them out.
If the system is in the open position, it is possible to insert the support fork of the seat in the bracket
and pull them out.
To move from the open to the closed position: Insert the key into the lock (fig. F) and rotate one
quarter turn clockwise.
To move from the closed to the open position: Insert the key into the lock (fig. F) and rotate a quarter
turn counter clockwise.
Mounting the Support Fork on the Seat
Place the seat on the head.
Position the support fork (17) under the seat (fig. G).
Place the screws (15) into the seat (fig. H).
Position the fixing plate (16) under the seat (fig. I).
Tighten the nuts (14) to fasten the support fork (fig. L).
WARNING: Periodically check the tightening of the nuts. These can come loose during use.
Assembling the Seat on the Bike
Be sure that the mounting support lock is in the "open" position.
Press the yellow button (6) and place the support fork (17) into the holes on the upper part of the
mounting support (fig. M).
WARNING: After successful insertion, make sure that the yellow button (6) is latched. If it is not
latched, the support fork (17) is not correctly inserted: Repeat the process.
Align the seat along the bike's axis.
Check that the seat does not interfere with the pedals, brakes, gears and any other moving parts of
the bicycle.
Leave enough space to be able to place the child in and remove it from the seat.
16