Husqvarna 130C Manual Del Usuario página 17

To replace the trimmer line (130L)
1. Hold the lower half (A) of the trimmer head with
one hand. Use your opposite hand to turn the top
half (B) of the trimmer head.
A
a) For straight shaft grass trimmers, turn the top
half of the trimmer head clockwise.
b) For curved shaft grass trimmers, turn the top
half of the trimmer head counterclockwise.
Note:
It is not necessary to push the top
half of the trimmer head down when you turn
it.
Note:
When you turn the top half of the
trimmer head, you will hear a click.
2. Continue to turn the top half of the trimmer head
until the triangle (C) aligns with the hole (D).
3. Remove and discard the remaining trimmer line.
4. Cut approximately 6.7 m/22 ft of new trimmer
line.
5. Put 1 end of the trimmer line into 1 of the holes.
1687 - 003 - 22.09.2021
6. Push the trimmer line through the trimmer head
B
C
7. Pull the trimmer line through the trimmer head
D
8. Hold the lower half of the trimmer head stable
and through the opposite hole.
until there is an equal length of trimmer line on
each side.
with one hand. Use your opposite hand to turn
the top half of the trimmer head. Continue to turn
the top half of the trimmer head until
approximately 127 mm/5 in of the trimmer line is
extended from each hole.
E
a) For straight shaft grass trimmers, turn the top
half (E) of the trimmer head clockwise.
b) For curved shaft grass trimmers, turn the top
half (F) of the trimmer head
counterclockwise.
Note:
If the trimmer line is too long on one
side of the trimmer head, cut the trimmer line
to the correct length.
F
17