Rear Panel Input/Outputs; Using Headphones; Other Equipment; Onnecting Othere - Bose WAVE MUSIC SYSTEM III Guia Del Usuario

Rear panel input/outputs

The rear panel of your Wave
connections for external equipment.
ANTENNAS
2.5 mm DAB and 3.5 mm FM antenna (75)
connectors
Bose ® link
Connects to Bose
products
AUX IN
3.5 mm stereo input connector
for external sources
HEADPHONES
A 3.5 mm stereo headphone connector (system
speakers are muted when headphones are con-
nected)

Using headphones

For private listening, connect headphones to the
headphone connector on the rear panel of the Wave
music system III.
HEADPHONE connector
(Headphones not included)
The speakers are automatically muted when you plug in
your headphones.
CAUTION: Long-term exposure to loud music may cause
hearing damage. It is best to avoid extreme volume when
using headphones, especially for extended periods.
Note: The speakers will automatically unmute when
headphones are disconnected from the Wave
system. Because headphone volume levels may vary from
speaker volume levels, be sure to lower the volume of the
music system III before connecting or disconnect-
Wave ®
ing headphones.
All manuals and user guides at all-guides.com
music system III provides
®
®
link-enabled
®
® music
C
ONNECTING
Note: If an alarm sounds while using headphones, it will
sound through the Wave ®
To change the headphones volume:
Press Volume or to adjust the listening
level of your headphones.

Using the AUX IN connector

When using a TV, DVD player, computer, video game or
other audio source, you can enhance your listening
experience by playing the audio device through your
music system III.
Wave ®
Connecting an audio device to your Wave
III requires one of the following cables:
• Male-to-male stereo cable
3.5 mm
• Dual RCA male to
3.5 mm male
To obtain the correct cable, contact Bose
Service or visit a local electronics store. See the contact
information inside the back cover of this guide.
To connect an audio device, such as your TV, to
music system III:
®
your Wave
1. Connect one end of the stereo cable to the output of
the audio device.
AUX IN connector
2. Connect the other end of the cable to the AUX IN
connector on the rear panel of your Wave
system III.
3. Press to turn on the system and select the
AUX input.
music system III is connected to a
Note: If your Wave ®
Bose ® link accessory, pressing AUX will toggle between the
AUX device input and the Bose link input.
O E
THER QUIPMENT
music system III speakers.
®
music system
stereo cable
®
Customer
Dual RCA male to 3.5mm
male stereo cable
® music
English – 17