Setting U P Your Wave; Unpacking; Selecting A Location; Connecting To Power - Bose WAVE MUSIC SYSTEM III Guia Del Usuario

S U Y
ETTING P OUR

Unpacking

Please check the shipping carton for the following items:
music system III
Wave ®
Remote control
(battery installed) Demonstration CD
*The appropriate power cord(s) for your region is supplied.

Selecting a location

music system III on a table or other
• Place your Wave ®
flat surface.
• To enjoy maximum audio performance, place your
music system III across the room from where
Wave ®
you will be listening.
• For best audio performance, place your Wave
system III within two feet of a wall, and avoid placing
directly in a corner.
Notes:
• Do not place your Wave
surface. It could interfere with AM reception.
• Do not place your Wave
sensitive surface. Like all electrical equipment, it gener-
ates some heat.
music system III in a damp
• Do not use your Wave ®
location or any other place where moisture can get
inside.

Connecting to power

1. Insert the small end of the power cord into the con-
nector labeled AC POWER on the rear panel of your
music system III.
Wave ®
2. Plug the power cord into an electrical outlet.
1
AC POWER
6 – English
All manuals and user guides at all-guides.com
®
W M
AVE USIC
AC power cord(s)*
3.5 mm input cable
®
DAB dipole antenna
Antenna adapter
(Europe & UK only)
®
music
music system III on a metal
®
music system III on a heat-
®
2
III
S
YSTEM
3. Unwind and straighten the power cord to ensure the
best FM and digital radio reception. The power cord
is used as an antenna.

Setting the clock

After plugging in your Wave
clock using the remote. Your Wave
easily operated using the remote control. Just aim the
remote at the front panel and press the necessary buttons.
1. Press and hold down either Time button for
about 1 sec.
Initially, HOLD_TO_SET appears on the display and
then quickly changes to – CLOCK SET – as the
button is depressed.
2. Release the selected Time button.
3. Press Time – to adjust the displayed time backward
or press Time + to adjust the displayed time for-
ward until it matches the current time. You can also
press and hold for rapid adjustment.
4. Wait five seconds for the system to exit the clock
setup mode automatically.
Notes:
• To change the clock display from 12-hour (AM/PM) time
to 24-hour time, see "Changing the time format" on
page 20.
music system III loses power due to a
• If the Wave ®
power outage or uplugging the unit to move it, all system
settings will be permanently retained. However, the clock
time will only be temporarily stored in backup memory for
up to 48 hours.
3
music system III, set the
®
music system III is
®
Note: Press-and-hold operations
require holding the button down for
about one second.