Mechanical Specifications - LEGRAND 4 306 93 Instrucciones De Montaje

12 IR LEDs
Heating 12 VDC
Camera
mounting
platform
The main control board is located below the camera's mounting platform
See below for more information
CONNECTING THE CONTROL BOARD'S TRIGGER OUTPUT (FOR COMPATIBLE CAMERAS)
IR adjust
(turn clockwise to
increase power)
Camera ICR control
- noir (earth)
- red (+5 V)
- orange (0 V)
E.g.: Connecting a camera housing: 4 306 60 and 4 306 61:
POE INJECTOR
PoE injector specifications
Input power requirements
AC input voltage:
AC frequency:
AC input current:
Power over LAN output specification
Pin assignments and polarity:
Output voltage:
Output current:

Mechanical specifications

Dimensions:
System indicator:
Caution: The camera ICR control output is used to synchronise the transition
from colour mode to black and white mode depending on the lighting of the
LEDs on the housing:
- If the LEDs are lit, the camera is in black and white mode.
- If the LEDs are off, the camera is in black and white mode.
Type of connection depending on the camera:
- If the IR trigger signal is in the high position (+5 VDC), connect the red and
black wires to the camera's D/N +/- trigger line.
- If the IR trigger signal is in the low position (+0 VDC), connect the orange and
black wires to the camera's D/N +/- trigger line.
- Orange wire to NA port.
- Black wire to G port.
138 mm
100 - 240 VAC
50 - 60 Hz
2A at 100 VAC, 1A at 240 VAC
(+) 4/5 (-) 7/8
Aggregate power: 30W +/- 5 % (48Vdc +/- 2V)
0 - 1A +/-5 %
(H) 3.8 cm × (W) 10.4 cm × (D) 13.8 cm
AC power (green)
Active power (red) 0.05 A<Io<1 A
Overcurrent protection (flashing red)
104 mm
POWER &
DATA OUT DATA IN
38 mm
ACTIVE
AC IN
100 ~ 240V
6
NOT USED
PoE+ INPUT
IEEE 802.3 at
PoE+ OUTPUT
IEEE 802.3 at
PoE power unit
Fan
Terminal block
POWER