English
1
Deutsch
3
Français
Español
中文
2. Environmental Requirements
日本語
Operating Temperature : 0 ~ 40 ℃ (32 ~ 104 F)
한국어
Storage Temperature : -10 ~ 70℃ (14 ~ 158 F)
Line Voltage: 100 ~ 240V AC
3. Hardware Requirements and Precautions
1. Only one interface connection may be used at once per computer system.
2. You are strongly advised to set the storage mode (the default is the Independent mode)
before using the ST2.
3. Under the independent mode, the ST2 series allows you to install two hard drives of
different model specifications and capacities; however, we do recommend that you use
two hard drives of the same model specifications and brand.
4. Please make sure that the two hard drives are free from bad blocks or defects prior to
installation in order to avoid system crashes or data loss.
5. The actual storage capacity of ST2 series recognized by the system may differ from the
total capacity stated on the hard drives combined once the drives have been formatted.
6. Whenever turning off or unplugging the ST2 series from your computer system becomes
necessary, always remember to safely remove it from your operating system before
powering off the device.
7. It is highly recommended for users to back up important data contained within the ST2
unit on a regular basis or whenever the user feels necessary to a remote or a separate
storage device. Stardom will not be responsible for any lost of data caused during the
use of the unit or the recovery of the data lost.
Once the drive mode configuration has been completed, re-configuration using the same hard
drives to set the drive mode will result in complete data loss. If you must change the drive
mode, make sure to backup all data prior to the mode change.
4
2
7
5
6
4
SOHOTANK ST2 Series User Manual
ST2-SB2
1. Power socket
2. Power switch
3. Cooling fan
4. Anti-theft cord slot
5. USB2.0 interface connection
6. eSATA interface connection
7. Storage mode switch
Note :