Trevi SB 8380 SW Guia Del Usuario página 12

ENGLISH
SUPPLY
- Connect the plug of the supplied power supply to the DC IN socket on the back of the sound bar and connect the
power supply to a power outlet.
- Insert the plug of the subwoofer's power cord into an electrical outlet.
ON / OFF AND AUTO POWER OFF FUNCTION
Turn on the subwoofer
1. Press the ON / OFF switch located behind the Subwoofer and turn it to the "ON" position to turn the unit on.
2. Press the button (6) on the remote control to turn on the Sound bar
3. The wireless connection between the soundbar and the subwoofer will take place automatically, if this does not
happen, turn off and on both devices or carry out the pairing operation:
- Select the bluetooth function using the BT key (2) (BT flashing on the display).
- Press and hold the Play / Pause button (11) on the remote control until PAIR appears on the display.
- Wait for the red light on the back of the subwoofer to change from flashing to steady.
Note:
• It takes a few seconds (or longer) for the connection between the Soundbar and Subwoofer.
• The closer the Soundbar and the subwoofer are, the better the sound quality will be. We recommend
placing the Soundbar and Subwoofer as close as possible and avoiding: --stacles between the
Soundbar and the Subwoofer. -- Devices that use the same frequency as the wireless connection,
such as a microwave oven, wireless LAN router, medical equipment.
Power on / Stand-by of the soundbar
1. Press the POWER button (1) or (6) on the remote control to turn on the Sound bar; after a few seconds the
Subwoofer will also turn on automatically.
2. Press the POWER button (1) or (6) on the remote control to put the soundbar in Stand-by mode; after a few
minutes the Subwoofer will also go into Stand-by mode automatically.
This device has an AutoPower Off function; this function allows automatic shutdown after a few minutes in the
absence of an audio signal on the inputs.
Nota:
• If the sound Base does not react to any operation or does not work properly, disconnect the power
cable for 30 seconds to reset the device.
Note:
• When connecting to the headphone output of a TV or a device that has its own speakers, these usually
are disabled and to have a good output signal need to adjust the volume to the maximum level through
the commands of TV (or device).
• When connecting to the audio output of a TV-Scart (or any audio output that is not the headphone jack
of another device), the level of the sound output is constant and not adjustable via the command own
the TV (or device); the speakers of the TV (or device) is not disabled and if you want to silence them
need to lower the volume completely otherwise the reproduction is in addition to the Sound Base.
12
SB 8380 SW