Filling With Water; Dry Ironing; Steam Ironing - Mellerware Steezy! Manual Del Usuario

Instructions for use
BEFORE USE
Make sure that all products'
–
packaging has been removed.
Some parts of the appliance
have been lightly greased.
–
appliance is used a light smoke
may be detected. After a short
time, this smoke will disappear.

FILLING WITH WATER

–
deposit with water to be able to
work with steam.
Open water inlet lid.
–
Fill the deposit taking care to
–
observe the MAX level (Fig.1).
Close water inlet lid.
–
USE
Extend the cable completely
–
before plugging it in.
Connect the appliance to
–
the mains.
Turn the thermostat control to the
–
desired temperature position.
Do not use temperatures higher
–
than those indicated on the
garments to be treated.
• Temperature for synthetic
fibres (Polyester, Nylon...) and silk.
•• Temperature for wool.
••• Temperature for cotton.
(Minimum temperature for

steam ironing)

MAX Temperature for linen.
If garment has various kinds of
–
temperature. (For example, select
the temperature for polyester
for an article made out of 60%
polyester and 40% cotton).
Wait until the pilot light (F) has
–
gone out which will indicate that
the appliance has reached an
adequate temperature.
During the appliance's use the
–
pilot light (F) will come on and
heating elements are working, and
therefore maintaining the desired
temperature.

DRY IRONING

–
regulator that permits dry ironing
(without steam) when placed in the
1 position.
STEAM IRONING
It is possible to iron with steam
–
with water and the adequate
temperature is selected.
STEAM FLOW CONTROL
The appliance has a control knob
–
(C) that allows getting the control
SPRAY
The spray can be used in both
–
steam and dry ironing.
Press the spray button (A) to use
–
this operation.
The spray button has to be
–
pressed repeatedly to release
EN