STEAM BLAST
This function proportions extra
–
steam for eliminating wrinkles.
Press the steam blast button (B).
–
Wait a few seconds until vapour
garment before pushing the button
again. For optimum steam quality,
do not apply more than three
successive blasts.
The steam blast button has to be
–
pressed repeatedly to release the
VERTICAL STEAMING
It is possible to iron hanging
–
curtains, items of clothing on his
hanger, etc. To do so, follow the
instructions:
- Select the maximum
temperature of the iron, while
turning the temperature
regulator of the iron in a
clockwise direction (Fig.2).
- Move the iron in a top
to bottom direction while
pressing the steam control
(B). Important: for cotton and
linen, it's recommended to
put the iron base in contact
with the material. For other
recommended to keep the iron
base at some centimetres
of distance.
ONCE YOU HAVE FINISHED USING
THE APPLIANCE
Select the minimum position (MIN)
–
using the thermostat control.
Unplug the appliance from
–
the mains.
Remove the water from the inside
–
of the appliance.
Clean the appliance.
–
Cleaning
Disconnect the appliance from the
–
mains and allow it to cool before
undertaking any cleaning task.
Clean the equipment with a damp
–
cloth with a few drops of washing-
up liquid and then dry.
Do not use solvents, or products
–
with an acid or base pH such as
bleach, or abrasive products, for
cleaning the appliance.
Never submerge the appliance in
–
water or any other liquid or place it
under running water.
SELF-CLEANING FUNCTION
It is important to self-clean the
–
appliance at least once a month
to remove calcium and any other
built-up minerals inside the iron.
Fill the depository to its maximum
–
level, as indicated on "water
Place the iron in the vertical
–
position, plug into the mains and
select the maximum temperature.
Leave the appliance to heat up
–
until the pilot light indicates that
it has reached its consigned
temperature.
Unplug the appliance and place in
–
the sink.
EN