System Info - IVIEW K Serie Manual Del Usuario

7.2 System Info

In this menu list, you can check or change some system settings.
Move to " " (SYSTEM INFO), and you will see a similar screen as the following:
SERIAL TYPE
BAUD RATE
HOST ID
PASSWORD
RESET DEFAULT
CLEAR HDD
UPGRADE
AUTO KEYLOCK (SEC)
LANGUAGE
VIDEO FORMAT
VERSION
PLEASE CONSULT YOUR INSTALLER FOR ADVANCE SETTINGS
SELECT BACK
The submenu items are described below:
1) SERIAL TYPE
Here shows the serial type of the DVR (RS-485).
2) BAUD RATE
Set the baud rate of the DVR (2400 / 9600 / 19200 / 38400 / 57600).
3) HOST ID
Set the ID of the DVR (0 ~ 254).
4) PASSWORD
Reset the password for accessing the DVR system. You can set the 4-digit password.
5) RESET DEFAULT
Press to reset all settings as default, and select "YES" to confirm or "NO" to cancel.
6) CLEAR HDD
Select the HDD you want to clear. Press
7) UPGRADE (For upgrading firmware / OSD)
Before using the USB flash drive, please use your PC to format the USB flash drive as FAT32 format first. Then,
save the upgrade file in a compatible USB flash drive, and insert it into the USB port at the front panel.
Press and select "YES" to confirm upgrade or "NO" to cancel.
Note: For the list of compatible USB flash drives, please refer to "APPENDIX 2 COMPATIBLE USB FLASH
DRIVE BRAND" at page 63.
8) AUTO KEYLOCK
Set the time-out in second after which the key lock function is activated (Never / 10 / 30 / 60).
9) LANGUAGE (Multilingual OSD)
Select the language of the OSD.
10) VIDEO FORMAT
All manuals and user guides at all-guides.com
SYSTEM INFO
1248-1012-1035-1018-M1-6C1B
NEXT ENTER
and select "YES" to confirm to clear HDD or "NO" to cancel.
~29~
RS485
2400
0
XXXX
RESET
HDD-MASTER-1
START
30
ENGLISH
NTSC
ADVANCED MENU