LEGRAND C2G C2G30026 Manual Del Usuario página 5

HDMI HDBaseT + RS232 and IR over Cat Extender Box
Transmitter to Box Receiver - 4K 60Hz
Product Overview
Front Panel
1 2 3 4
F P D
RONT ANEL ESCRIPTION
On: Power is applied to the device.
1 Power LED
Off: No power is applied to the device.
Blinking: The device is working properly.
2 Status LED
Off: The device is not working properly.
On: HDCP protected content is being transmitted.
3 HDCP LED Blinking: Non-HDCP protected content is being transmitted.
Off: No content is being transmitted.
On: HDBT link is normal.
4 Link LED
Off/Blinking: No HDBT link or link error.
Set the function of RS232 port.
PASS-THROUGH: RS232 port is used to pass-through RS232
commands over HDBT.
5 RS232
MCU: RS232 port is used to update MCU firmware.
VS: RS232 port is used to update VS firmware.
Note: Transmitter and receiver can only be updated separately.
Receiver
5
Rear Panel
8
6 7
R P D
EAR ANEL ESCRIPTION
Connect to the power adapter provided. With bi-directional
6 DC 18V PoC function supported, connect the power adapter to the
transmitter or the receiver and power both units.
7 HDBT IN Connect to the transmitter via a Cat 5e/6/6a/7 cable.
8 IR IN Connect to the IR receiver provided.
9 IR OUT Connect to the IR emitter provided.
For RS232 pass-through or firmware upgrade.
10 RS232
11 HDMI OUT Connect to an HDMI display device.
3
Receiver
10
9 11
(us)