Package Contents; Mounting Bracket Installation - LEGRAND C2G C2G30026 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

HDMI HDBaseT + RS232 and IR over Cat Extender Box
Transmitter to Box Receiver - 4K 60Hz
Features
Supports resolutions up to 4K@60Hz 4:4:4 8bit and HDCP 2.2
Supports HDR (High Dynamic Range), including HDR 10 and Dolby Vision*
Supports signal transmission up to 100m/330ft for 4K@60Hz 4:4:4 8bit and 1080P via
a single Cat 6a/7 cable
Supports signal transmission up to 70m/230ft for 4K@60Hz 4:4:4 8bit and up to 100m/330ft
for 1080P via a single Cat 5e/6 cable
Bi-directional PoC, one power adapter at either transmitter or receiver side can power both units
Supports bi-directional IR and RS232 pass-through
Supports CEC pass-through
*Note: This kit supports Dolby Vision only if the data rate is less than or equal to 10.2Gbps.

Mounting Bracket Installation

Note: Before installation, please ensure the unit is disconnected from the power
source.
1. Remove the screws from one side panel of the unit.
2. Attach the installation bracket to the enclosure using the screws that were
provided in the package separately. The bracket height can be adjusted up/
down or bracket face up or down.
3. The bracket is attached to the enclosure as shown.
4. Repeat steps 1-2 for the other side of the unit.
5. Attach the brackets to the surface you want to mount to using screws (not
included).
6. Repeat the steps from 1 to 5 to install the receiver.
4

Package Contents

1 x Transmitter
1 x Receiver
1 x DC 18V Power Adapter with US, UK,
EU and AU Pins
1 x IR Emitter
1 x IR Receiver
2 x Phoenix Connector (3.5mm, 3 Pins)
4 x Mounting Bracket (with screws)
1 x Manual
(us)

Publicidad

Tabla de contenido
loading

Tabla de contenido