Maintenance And Repairs - Duronic SADT2 Manual De Instrucciones

• Avoid exposing the screen to direct sunlight,
spotlight or any other heat source.
• Do not use alcohol or ammonia base liquid to clean the screen.
The cleaning information provided in the section "Cleaning and Storage".
• Please do not attempt to repair the appliance yourself.
This could result in serious injuries.
Failure to observe this regulation shall void the warranty.
• If this appliance is damaged in any way or it is not working,
it should not be operated.
Please try to fix the problem according to FAQ table.
• If the problem is still not resolved, please contact customer service or the
dealer, since special tools are needed to make repairs.
Never try to repair the appliance yourself.
1. Remove the stand from the stand storage cavity.
2. Insert the end of stand into the hole on the back of appliance.
3. Place the appliance on a solid surface approximately
20 - 30cm from your eyes, the light must bathe your face from the side.
4. Connect the appliance only to the mains voltage listed on the type plate.
• Push the plug completely into the mains socket.
• Ensure that there is a socket near the place where the appliance will stand.
• Lay the mains cable in such a way that no one can trip over it.

Maintenance and Repairs

Unit Desciption
Installation
9