Setup; Operation - Duronic PS815 Manual De Instrucciones

1. Carefully place the PS815 shredder on a dry, flat, level surface.
2. Place the shredder head into the top of the waste bin.
3. Be careful not to place your fingers near the cutter blades.
4. Plug the power cord into any standard 220-240-Volt AC mains outlet / plug
socket which shall should be located near the equipment and should be
easily accessible.
5. Place the switch into the AUTO position.
The power switch is located on the top of the shredder. The switch has four
settings: Forward/FWD, AUTO, OFF, Reverse/REV.
When AUTO is selected, the shredding process is started automatically by
inserting paper into the feed opening. The shredder will also stop automatically
when the paper has completed its travel through the feed opening.
REV mode is used to assist in the removal of a paper jam. This reverses the
shredding process before the cycle finished, thus clearing the cutters.
FWD mode is also used to assist in the removal of a paper jam. By selecting
this mode, the machine's blades will keep rotating continuously even if no
paper is inserted. This will help clear the blades and remove any remaining
pieces of paper from the blades.
Select the OFF mode when emptying the waste bin or when the shredder is
not in use for a long period of time.

Setup

You are now ready to start shredding.

Operation

10