Stanley IntelliSensor Pro Manual De Instrucciones página 7

109F Manual (B/E/F)
Detecting Wood Studs
1. Slide the unit across the surface in a
straight line. The closer the unit is to the
stud the more bars will be shown as
illustration 6. When the stud edge is
detected the Wood indicator and the
edge bar will be shown as illustration 7
and the unit will sound a continuous
beep.
2. Use indicator graphic (illustration 2&7)
and indicator mark (illustration 1) to
locate and define stud edge.
3. Continue sliding past the stud. When the
indicator turns off and the unit stops
beeping the other edge has been
detected.
4. Double check stud location by coming
back from the other direction. Make
additional markings.
5. The midpoint of the marks indicates the
stud center.
READY
READY
ILLUSTRATION 6 ILLUSTRATION 7
7
7 17/2/05, 3:38 PM