Volume Adjustment - Porter Cable PCCR701 Manual Del Usuario

Fig. B
14
2. Pull the battery door open.
3. Install the coin cell battery according to the diagram
inside the coin cell battery area.
4. Replace the battery door, insert the screw and tighten.
nOTE: To reset the LCD display clock remove the coin
cell battery for a few minutes and then re-install. Follow
this procedure if the screen seems to locked in place and
tighten securely.
Installing and Removing
the Battery Pack (Fig. C)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack 17
battery pack with the rails on the battery port
it into the radio until the battery pack is latched and firmly
seated and you have ensured that it does not disengage.
To remove the battery pack from the radio, press the release
button and firmly pull the battery pack out.
18
Fig. C
17
Tool Placement (Fig. D)
Place the charger / radio on a smooth, level surface as shown
in Fig. D.
Fig. D
All manuals and user guides at all-guides.com
16
into the radio, align the
13 and slide
18
13
On/Off - Volume Dial
• To operate as a corded product, insert the AC plug
into an appropriate AC power outlet or generator.
• To operate as a cordless product, insert a fully charged
20v Max* PORTER-CABLE battery (not included) into the
battery port 13 . Be sure battery is fully seated.
1. To turn the radio ON, press the ON/OFF - be sure battery
is latched and fully seated.
2. Press the ON/OFF - Volume dial again to turn the
radio OFF.

Volume Adjustment

1. Rotate the ON/OFF - Volume dial
increase the volume.
2. To decrease the volume, rotate the ON/OFF -
Volume dial 1 counter clockwise.
nOTE: If the battery is attached to the radio and the AC
plug is plugged in at the same time, the radio will run off
of the AC power and not drain the battery. Having both
attached simultaneously will prompt the unit to charge
the battery.
Mode Function
To choose one of the mode functions (FM, AM, or AUX)
push the mode button 2 until the desired function is
displayed on the LCD. For example, if the radio is on FM,
push the mode button two times to change to AUX.
nOTE: The first press on any buttons when the back light is
off, will wake the unit up. Press the desired button again to
activate the function.
Tune or Seek Function
To Tune:
• Press the right tune / seek button
the tuner up the frequency band. To move the tuner
down the frequency band, press the left tune /
seek button.
To Seek:
• Press and hold the right tune / seek button
release to quickly scan up the frequency band to the
next available station. Press and hold the left tune /
seek button 8 , the release to quickly seek down the
frequency band.
To Program The Clock
The clock can be programmed with the power ON.
1. Press and hold the clock button
numbers of the digital time flash on the LCD
release the clock button.
2. Rotate the ON/OFF-Volume dial
seek buttons 8 to set hour.
3. When the correct hour is set, press the clock button
once so the minute numbers flash.
English
10
1 clockwise to
8 to quickly move
, then
8
7 until the hour
5 , then
1 left or right to tune /
7