Escription; Rear Panel; Remote Control Unit - Samsung DSB-A200C Instrucciones De Uso

2/27/04 3:22 PM Page 6
DESCRIPTION
nel
2 3 4 5 6 7
This key is for turning the receiver on and Standby.
This key is for entering and confirming any data to the receiver in the
menu system. This key is for selecting the item. Press while viewing
TV and a list of channels is displayed.
These keys are for changing the channels during watching TV and for
moving the highlight bar for selecting options on the menu.
These keys are for increasing and decreasing the volume level
manually during watching TV and for moving the highlight bar for
selecting options on the menu.
t Slot for Viaccess smartcard. (For models DSB-A300V, DSB-A300W)
nt Display This LED display will show the current channel number.
While the receiver is in Standby mode, the display will
show the current time.
Sensor This is to receive the IR commands from the Remote
Control Unit.
le Slot In the slot you can use a CA module from a service provider
of your own choice. (For models DSB-A200C, DSB-A300W)
N N o o t t e e : CA modules and smart cards are only distributed by service
Providers and special distributors, not by SAMSUNG.
GB-6
All manuals and user guides at all-guides.com
8
D I G I T A L S A T E L

Rear Panel

8
11 10 9 7
1. AC MAINS This is to plug in the AC mains power cord.
The input AC voltage range is 100V to 240V~, 50Hz/60Hz supply.
2. 0/12V This is for connecting to an external LNB switch.
3. RS 232 DATA PORT This is for connecting your receiver to a computer for reading
and loading data information.
4. ANT.IN This is for connecting your local RF channels to your TV through Loop.
5. RF OUT This is for connecting to your TV via RF cable.
6. AV SCARTS This is for connecting to your AV scarts for TV & VCR or
DVD player.
7. COLOR COMPONENT(Y, Pb, Pr)
This is for connecting STB to your TV by using COLOR
COMPONENT(Y, Pb, Pr) cable. To view a normal picture by
connecting a color component cable, set the video signal
type to Composite + YUV in Media Setting mode.
8. VIDEO, AUDIO R/L These RCA connectors are for connecting any external video
and audio.
9. DIGITIAL AUDIO OUT(OPTICAL)
Output for connection to a digital amplifier.
10. LOOP To enable the connection of an Analog receiver.
The receiver is provided with this 'LOOP' port.
11. DISH INPUT This port is to connect the coaxial cable from LNB of your dish.
The IF input is provided through this port and the input frequency
range is 950-2150 MHz. Also the voltage switching 13V and
18V is passed through this port.
L I T E R E C E I V E R
DESCRIPTION
6 5 4 3 2 1
GB-7