Setting The Fm Tuning Step; Setting The Am Tuning Step; Additional Information; Setting The Time Display On Or Off - Pioneer SUPER TUNER III Manual Del Usuario

Initial Settings

Setting the FM tuning step

The tuning step employed by Seek Tuning in the
FM mode can be switched between 100 kHz
(preset at the factory) and 50 kHz.
1 Press to select
AUDIO
Press repeatedly until
AUDIO
the display.
2 Select the FM tuning step with 2/3.
Note
• If seek tuning is performed in 50 kHz steps,
stations may be tuned in imprecisely. Tune in
the stations with manual tuning or use seek
tuning again.

Setting the AM tuning step

The AM tuning step can be switched between 9
kHz, the preset step, and 10 kHz. When using
the tuner in North, Central or South America,
reset the tuning step from 9 kHz (531 – 1,602
kHz allowable) to 10 kHz (530 – 1,640 kHz allow-
able).
1 Press to select
AUDIO
Press repeatedly until
AUDIO
the display.
tuning step with 2/3.
2 Select the
AM
Pressing 2/3 will switch the AM tuning step
between 9 kHz and 10 kHz. The selected AM
tuning step will appear in the display.
15
En
All manuals and user guides at all-guides.com
.
FM STEP
appears in
FM 100
.
AM STEP
appears in
AM 9

Additional Information

Setting the time display on or off

You can turn the time display on even when the
sources are off.
Press to select the time display.
CLOCK
Each press of turns time display on or
CLOCK
off.
• The time display disappears temporarily when
you perform other operations, but the time indi-
cation is displayed again after 25 seconds.

CD player and care

• Use only CDs that have the Compact Disc
Digital Audio marks as shown below.
COMPACT
DIGITAL AUDIO
• Use only normal, round CDs. If you insert
irregular, non-round, shaped CDs they may
jam in the CD player or not play properly.
• Check all CDs for cracks, scratches or warped
discs before playing. CDs that have cracks,
scratches or are warped may not play prop-
erly. Do not use such discs.
• Avoid touching the recorded (non-printed
side) surface when handling the disc.
• Store discs in their cases when not in use.
• Keep discs out of direct sunlight and do not
expose the discs to high temperatures.