Sauder Barrister Lane 422268 Manual Del Usuario página 9

Step 5
Separate the EXTENSION SLIDES (S) from the EXTENSION RAILS (R) as
å
shown in the upper diagram below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (R) to the ENDS (A and B). Use four GOLD 5/16"
å
FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the
å
enlarged diagram. Then, slide the inner cartridge of the EXTENSION RAIL in to
fi nd the other hole that lines up with the hole in the END. Turn a SCREW into
this hole.
NOTE: The EXTENSION SLIDES will be used later for the DRAWER UPRIGHTS.
å
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
Open end
www.sauder.com/services
S
Push the black lever in and pull the SLIDE from the RAIL.
3S
This hole
must be here.
R
B
R
422268
Open end
R
A
Page 9