Using The Air Conditioner - Uline H-7100 Manual Del Usuario

FREEZING CONDITIONS: This is a cooling only air
conditioner. It is not designed for freezing outdoor
conditions. It must not be used in freezing outdoor
conditions.
REMOTE CONTROL: To ensure proper operation when
using the remote control, aim the remote directly at the
signal receiver on the air conditioner.
• The remote control has a signal range up to 20 feet.
• Make sure nothing is blocking the remote control
signal from being received by the air conditioner.
• Make sure the batteries are installed correctly and
still have power.
COOLING MODE: Use the cool mode at high, medium,
low fan speed when cooling is needed. Use the
temperature ▲ or ▼ buttons to set the desired
temperature between 61°F to 90°F.
• Once the temperature is set, the compressor will
cycle on and off to keep the room temperature
at the set temperature level. The lower the set
thermostat temperature, the cooler the room will
be. The higher the set thermostat temperature, the
warmer the room will become.
• For normal cooling, set the mode to cool and the
fan to high or medium with the temperature set in
the middle.
• For maximum cooling, set the mode to cool and the
fan to high with a lower set temperature.
• For quieter and nighttime cooling, set the mode to
cool and the fan to low with the temperature set in
the middle.
ENERGY SAVER MODE:
• When the energy saver mode is on, the fan will
cycle on and off with the compressor. This results in
wider variations of room temperature and humidity.
Normally, it is used when the room is occupied. The
fan may continue to run for a short time after the
compressor cycles off.
• When the energy saver mode is off, the fan runs all
the time in fan or cool mode.
PAGE 7 OF 27

USING THE AIR CONDITIONER

FAN ONLY MODE: Use fan only mode at high, medium,
or low fan speed to provide air circulation and filtering
without cooling. Since fan only setting does not provide
cool, a set temperature cannot be entered. The room
temperature will appear in the display.
LOSS OF POWER PROTECTION: If power to the air
conditioner is lost or interrupted, the air conditioner
will automatically restart in the setting last used prior to
power loss. Timer will be cancelled when power is lost or
interrupted. You may need to set a new timer if desired.
AIR DIRECTION: Use the lever on the front air vents to
adjust the airflow direction. You can direct the airflow to
left, right, up or down. The lever is located on the lower
left and right side of the air vent.
AUTO MODE: The air conditioner will automatically
choose cool or fan mode based on current room
temperature.
VENTILATION: In order to maintain the best cooling
condition, pull the fresh air lever to close the vent. When
fresh air is necessary, push the fresh air lever to open the
vent allowing fresh air being re-circulated in the room.
(See Figure 9)
Figure 9
0621 IH-7100