Electronic Control Panel; Fan Speed; Normal Operating Sounds - Uline H-7100 Manual Del Usuario

ELECTRONIC CONTROL PANEL

NOTE: The control panel display always shows
the room temperature in fan mode, except
when setting the temperature and timer.
2
COOL
DRY
FAN
AUTO
MODE
MODE
5
6
TEMP/TIME
8
3
1
1. POWER ON/OFF: Turn the air conditioner on and off.
2. DIGITAL DISPLAY: Will display set temperature when
the unit is in cool, dry, auto, sleep, energy saver
mode and display current room temperature when
in fan mode.
3. TEMPERATURE SET: Use these buttons on the control
panel or remote to increase or decrease the set
temperature.
4. TIMER SET: Use these buttons on the control panel
and remote control to set the timer. Each press of
the ▲or▼ button will increase or decrease the timer.
For timer instructions see number seven below.
5. FAN SPEED: Use the fan speed button to change the
fan speed. Choose between high, medium and low.
PAGE 5 OF 27
CONTROL PANEL
9
SLEEP
MODE
ENERGY
HIGH
SAVER
CHECK
MED
FILTER
TIMER
LOW
ON/OFF
SPEED DELAY TIMER
7
FILTER/RESET TEMP/TIME
4
6. MODE BUTTON: Press the mode button to cycle
through the various modes: auto, sleep, energy.
7. AUTO-ON TIMER: When the air conditioner is off, it
can be set to automatically turn on in 1 to 24 hours
at the previous set mode and fan settings. To set the
auto-on timer, press the delay timer button on the
unit or remote control. Timer can be set in one hour
increments.
AUTO-OFF TIMER: When the air conditioner is on, it
can be set to automatically turn off in 1 to 24 hours.
To set the auto-off timer, press the delay timer button
on the unit or remote control. Timer can be set in
one hour increments. Once timer is set, timer on/off
indicator on control panel will light up, as will the set
temperature, shown on digital display.
• To see the remaining time, press delay timer button.
To change the timer settings, use the control panel
or remote control.
• During preview of timer setting, press delay timer
button once to display set time, press it one more
time to cancel the settings.
8. FILTER RESET: After the fan rotates for 250 total hours,
the filter check light will turn on to remind the user
to clean the filter. Press the filter reset button to reset
the reminder once the filter is cleaned.
9. SIGNAL RECEIVER: Point the remote control to the air
conditioner when sending instruction to the unit.

NORMAL OPERATING SOUNDS

• A pinging noise may be heard, caused by water
hitting the condenser on rainy days or when the
humidity is high. This helps remove moisture and
improve efficiency.
• The thermostat may click when the compressor
cycles on and off.
• Water will collect in the base pan during rain or
days of high humidity. The water may overflow and
drip from the outside part of the unit.
• The fan may run even when the compressor is not on.
0621 IH-7100