Blower Operation - Armor All AA255 Manual Del Usuario

1
6
This Wet/Dry Vacuum has blowing capabilities. To use the blower feature, follow the instructions listed.
WARNING:
ALWAYS WEAR SAFETY GOGGLES COMPLYING WITH ANSI Z87.1 (OR IN CANADA,
CSAZ94.3) BEFORE USING BLOWER.
CAUTION:
KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
WARNING:
WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE INHALED.
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Make sure the collection tank is empty before using as a blower. Clear all dirt and debris from the hose and collection
tank.
3. Remove hose from the vacuum port.
4. Insert the larger end of the hose into the blower port on the back side of the power head (Fig. 2).
5. Choose the desired attachment and insert onto the end of the hose (Fig. 3).
6. Verify that the on/off switch is in the 'O' OFF position before plugging the power cord into the outlet. Plug the power
cord into the outlet (Fig. 4 & 5).
7. Before turning on the vacuum, firmly hold the loose end of the hose. Turn the motor on by flipping the switch to the 'I'
ON position (Fig. 6).
8. Once you have completed blowing, flip the on/off switch to the 'O' OFF position. Unplug the power cord from the outlet
(Fig. 7).
1

BLOWER OPERATION

2 3
7
MAINTENANCE
2
3
4
4
10
5
5