Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
LIQUID VACUUM OPERATION
1
6
LIQUID VACUUMING
WARNING: BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION ENTITLED "IMPORTANT
SAFETY INSTRUCTIONS". DO NOT VACUUM IN AREAS WITH FLAMMABLE GASES, VAPORS, OR
EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE GASES OR VAPORS INCLUDE BUT ARE NOT LIMITED TO:
LIGHTER FLUID, SOLVENT TYPE CLEANERS, OIL-BASED PAINTS, GASOLINE, ALCOHOL, OR AEROSOL
SPRAYS. EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO: COAL, MAGNESIUM, GRAIN, OR
GUN POWDER. TO REDUCE THE RISK OF HEALTH HAZARDS FROM VAPORS OR DUST, DO NOT
VACUUM TOXIC MATERIALS.
WARNING:
DO NOT PLUG THE POWER CORD INTO A POWER OUTLET. MAKE SURE PLUG IS
DISCONNECTED BEFORE CHANGING THE FILTERS.
1. Verify that the power cord is disconnected from the outlet. Make sure that the collection tank is clean and free of dust
and dirt (Fig. 1).
2. Remove the reusable cloth filter, then carefully install the foam wet filter over the filter cage and place the power head
back on the collection tank. For foam wet filter installation instructions, see page 12 (Fig. 2 & 3).
3. Place the power head back on the collection tank and secure it in place using the latches (Fig. 4).
DO NOT USE THE REUSABLE CLOTH FILTER FOR LIQUID VACUUMING.
OPERATING INSTRUCTIONS: WET VACUUMING
4. Push the required attachment onto the free end of the hose (Fig. 5).
5. Verify that the on/off switch is in the 'O' OFF position before plugging the power cord into the outlet. Plug the power
cord into the outlet (Fig. 6 & 7).
6. Turn the motor on by flipping the switch to the 'I' ON position (Fig. 8).
7. Once you have completed vacuuming, flip the on/off switch to the 'O' OFF position and unplug the power cord from the
outlet.
8. After use, empty the collection tank, clean and dry the inside and outside of the collection tank (Fig. 9).
IMPORTANT! When vacuuming large quantities of liquids, do not immerse the nozzle completely in the liquid; leave a
gap at the tip of the nozzle opening to allow air inflow. The machine is fitted with a float valve that stops the suction action
when the collection tank reaches its maximum capacity. You will notice an increase in motor speed. When this happens,
turn off the machine, disconnect from power supply, and empty the liquid into a suitable receptacle or drain. To continue
vacuuming, refit the power head to the collection tank. After wet vacuuming, turn the machine off and remove plug from
power supply. Empty the collection tank, clean and dry the inside and outside before storage.
REMEMBER! The foam wet filter must be removed after wet vacuuming and the reusable cloth filter must be installed
before dry vacuuming again.
2
3
7
8
4
9
9
5
Publicidad
Tabla de contenido
