Tripp-Lite B162-001-POE Guia De Inicio Rapido página 6

Installation
1 Connect a video source device to the HDMI Input Port on the
B162-001-POE transmitter using an HDMI cable.
2
Connect a video display device to the HDMI Output Port on
the B162-100-POE receiver using an HDMI cable.
3
Set up the units as follows:
Point-to-point setup:
3a
3b
Multipoint-to-multipoint setup:
3a
3b
-06-096-933E85-Book.indb 6 -06-096-933E85-Book.indb 6
Connect one end of an Ethernet cable to the LAN Port
on the transmitter and the other end of the cable to the
receiver's LAN Port.
Plug the power adapters into the Power Jacks on the
transmitter and receiver, and into an AC wall outlet,
Tripp Lite Surge Protector, PDU or UPS.
Install the transmitter and receiver to the same local
area network by connecting the LAN Ports to an Ethernet
switch using Ethernet cables.
The unit can be powered on through an Ethernet cable
if connected to a PoE-supported Ethernet switch.
Alternatively, plug the power adapters into the Power
Jacks on the transmitter and receiver, and into an AC wall
outlet, Tripp Lite Surge Protector, PDU or UPS.
Note: When power is supplied from both the power adapter and
the Ethernet cable (PoE), the supply from the power adapter will
be prioritized.
6
10/18/2021 1:55:38 P 10/18/2021 1:55:38 P